| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-05-2009, 06:45 AM
| ||||
| ||||
i joined this forum because i was looking for help in homing the turret on a KIA CNC lathe. i finished it yesterday, what a pain. the instructions just are not specific enough to make it easy. Had to figure much of it out by trial and error. But then of course some of the problems were due to not reading the instructions carefully enough. But at least it is done.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TL-1 Turret problems | RDemets | Haas Mills | 10 | 04-28-2008 02:46 PM |
| timing the turret | allmotormatt | Haas Lathes | 10 | 01-08-2008 07:22 PM |
| Help on cnc turret | bluelakesheety | General Metal Working Machines | 1 | 12-04-2007 10:40 AM |
| Turret won't clamp | protrxrptr17 | General Metal Working Machines | 6 | 12-28-2006 08:12 PM |
| Bolt on Turret 'v' VDI Turret | scappini | General Metalwork Discussion | 0 | 07-20-2006 06:59 AM |
| | |
Linear Mode
