07-28-2009, 11:40 AM
|
| | | Join Date: Jul 2009 Location: UK
Posts: 1
| |
Hi all,
Firstly this my first post so ill start with an introduction. I'm based in the UK and i look after 50+ CNC machine tools from Studers, Hermel's and Okuma's with mostly Fanuc & Siemens controls. So if i can offer advice out i will do my best to guide..
My question though is as follows - I have Hermel 800U with TNC 430 control, using a radio DNC via RS232 we have been transferring programs with no problems.
However after a recent HDD change due to failure i can no longer transfer programs in!! but out is ok..
I have been through params MP5020.0 etc to make sure settings are correct and sure enough they seem fine.
Anybody any ideas or guidence?? 
Thanks in advance
Tony |
Linear Mode
