![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
| |||
| |||
I know nothing about computer graphics but i have a ideal for the gecko banner, what software would i use to make it with. I tried photoshop but the size was 198k for a blank panal. Any suggestions for a computer challenged wannabe like myself? Thanks. Chuck
__________________ Aspire, VCPro, PhotoVCarve, Cut3D, Mach3, Home built CnC. |
|
#2
| ||||
| ||||
| Swishmax is like flash only a heap easier, and it can make animation. It has a 30 day full working free trial. Realdrawpro is a beauty. Same deal with the trial. Hope that helps. Other than that, you can wait for the next competition that will be aimed at skills other than drawing. |
|
#6
| |||
| |||
| CRFultz, I have photoshop elements (yeah, I'm cheap ) and there is an option to "save for web". This will radically reduce your image file sizes. Might be worth a go?!
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#7
| ||||
| ||||
| Kong, The "save for web" will get you a smaller file. In Photoshop Elements, you can control it further using Image->Resize->Image Size. Adjust your pixels/inch to a smaller number to reduce the file size. Make sure the width and height are correct. Bill |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engraving Software | The Wizard | General CAM Discussion | 31 | 03-29-2005 06:38 AM |
| Software sales or "license transfers" | metlmunchr | BobCad-Cam | 3 | 07-05-2004 05:47 PM |
| ***One stop CNC software guide*** | ynneb | DIY-CNC Router Table Machines | 4 | 05-27-2004 05:31 PM |