Looking for a supplier - CNCzone.com-The Largest Machinist Community on the net!

CNCBoss · #1 02-18-2005, 10:31 AM

I am looking for a supplier that has or can make jaw pads for an 15" SP counter-centrifugal chuck. The OEM has sold out. ITW workholding wants $990.00 per set of 3. I found another supplier in Houston TX wanting $390.00 for a set of 3. I bought three sets from him, took a long time to get them. Then sent a check for the next batch of 3 sets....I've been had! No jaws, no refund. SO...now I need a new supplier. If anyone know of a reputable company please advise. Thanks for your help.

wms · #2 02-18-2005, 12:48 PM

Might try these guys:

US Shop Tools
800-243-7701
www.usshoptools.com

DareBee · #3 02-18-2005, 02:15 PM

Send me a print. I will quote them if you wish.

CNCBoss · #4 02-18-2005, 02:47 PM

Thanks DB, I have to get a print made. I've been buying these from suppliers that already have the print.

CNCBoss · #5 02-21-2005, 09:36 AM

Thanks to all. I found a supplier in Ohio. He has the jaw pads I am looking for in stock. I appreciate everyone that took the time to read my post and try to help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Supplier for Octagonal tube/barstock	Deviant	General Metalwork Discussion	5	02-12-2011 12:24 AM
canadian supplier threaded rod?	rickkun	DIY-CNC Router Table Machines	4	02-12-2006 12:50 PM
Metal Supplier in Colorado Springs - Where?	creative_mind	General Metalwork Discussion	3	02-02-2005 02:03 PM
Supplier of Plastic Hex Bolt Covers - Where?	creative_mind	CNCzone Club House	3	12-30-2004 10:23 AM
End Mill Bit Supplier?	UCFMems	General Metalwork Discussion	3	08-11-2004 03:21 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)