02-10-2005, 02:44 PM
|
 | Community Moderator | | Join Date: Apr 2003 Location: teh Debug Window
Posts: 1,877
| |
 Facemilling: 300 cubic inches per minute | |
If you're familiar with material removal rates, this should raise the hair on the back of your necks... If you're not familiar with it, how does .75" Depth of Cut, 18.0" Width of Cut, at (I think it was) 22 IPM feed.. in steel sound? See the video.. 
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
Similar Threads 
Linear Mode
