| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
03-31-2009, 06:41 PM
| ||||
| ||||
Everyone getting ready for tomorrow? Evidentially if you can boot up in safe mode, your computer is not infected with it. Conficker prevents safe-mode boot. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
#2
03-31-2009, 06:50 PM
| ||||
| ||||
| I was just reading an article on MSN, about that virus. I'm updating as of the last few min. Might be a April fool hoax (better safe than sorry)? I'll tell you what, I had a virus on one of my PC, about 6 months ago, the only way I could get rid of it was to burn a linux disk, to clear out the virus, took about an hour to clean up the PC. .
__________________ Free DXF Files - Vectorink.com - myDXF.blogspot.com |
|
#3
04-02-2009, 10:36 PM
| ||||
| ||||
__________________ Toby D. "Imagination and Memory are but one thing, but for divers considerations have divers names" Schwarzwald (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) www.refractotech.com |
|
#4
04-02-2009, 11:01 PM
| |||
| |||
| Here is good info on conficker along with several tools to clean it or detect it. http://iv.cs.uni-bonn.de/wg/cs/appli...ning-conficker |
|
#5
04-02-2009, 11:06 PM
| ||||
| ||||
| Thanks!!
__________________ Toby D. "Imagination and Memory are but one thing, but for divers considerations have divers names" Schwarzwald (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) www.refractotech.com |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 0m not ready | f32cpe | Fanuc | 9 | 03-09-2009 05:07 PM |
| Ready to use and plug | Kelinginc | Automation Technology Products | 6 | 04-06-2008 12:25 AM |
| Taig CNC ready, how ready is that? | JB_in_Fla | Taig Mills & Lathes | 10 | 03-31-2008 05:47 PM |
| Getting ready to put it together. . | justCNCit | Linear and Rotary Motion | 4 | 06-13-2007 01:35 AM |
| Getting ready to cut | landart | DIY-CNC Router Table Machines | 3 | 08-27-2005 11:10 AM |
| | |
Linear Mode
