make a brushless servo use pic or avr for cnc controller,let's go! - CNCzone.com-The Largest Machinist Community on the net!

xosliu · #1 03-07-2009, 09:58 PM

since 2005 somebody began post this , but now we can't saw any usefull and simple brushless servo in web! let's go to talk!

alex7street47 · #2 09-20-2010, 04:01 AM

i think, you would need 6 TR to drive it.

bedrive · #3 09-20-2010, 05:12 AM

i thinks you can begin with dpsic or xmega

b.r

mactec54 · #4 09-20-2010, 09:08 AM

xosliu

Here is just what you have been looking for, this is low cost & a very good AC servo system made by Dmm Technology

http://www.dmm-tech.com/

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
HappyServo - Open Source Brushless Servo Controller	DerekZahn	Open Source Controller Boards	27	07-30-2010 09:06 AM
help dc brushless servo	zet-jaro	Servo Drives	11	02-23-2010 04:44 PM
Make a Driver For Servo Brushless Motor Up to 1.5Kw	Chivo	Servo Motors and Drives	5	09-13-2009 04:47 AM
DIY Brushless Servo Motor ?	epineh	Open Source CNC Machine Designs	11	06-14-2009 10:29 AM
I'm looking for a simple speed controller for a brushless AC motor.	trilect	General Electronics Discussion	4	05-11-2005 08:45 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)