| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-28-2009, 12:57 PM
| ||||
| ||||
I have been looking at this product STMD it is a Atmel uC based controller. 1. DMOS driver chips rated at 55V and 3 Amps. (LMD18245T) # Full Step, Both Phases On # Full Step, Wave Drive # Half Step # Quarter Step # Sixth Step # Eighth Step # Tenth Step # Twelfth Step # Sixteenth Step 2. Optically isolated step, direction, & enable signals. It looks like a very good product. I have been looking at these motors: STP-MTR-23079 The current rating is 2.8A/Phase. 276 0z-in. Do you think I'm cutting it a little close on the current? Once I get the controllers, motors, power supply and assuming I have the X,Y, Z axis what more for electronic hardware do I need? I plan to use linux and EMC2 as the software to control everything. Thanks for the help.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which motors and controllers?? | MasterSmeat | Want To Buy...Need help! | 1 | 10-18-2010 07:14 AM |
| Motors and Controllers? | djmickyg | CNC Wood Router Project Log | 4 | 09-07-2007 03:33 AM |
| steper motors & controllers | spoolin_20b | DIY-CNC Router Table Machines | 2 | 08-05-2007 12:06 PM |
| What Controllers and Motors should I get?? | RMS | DIY-CNC Router Table Machines | 29 | 06-29-2006 07:18 PM |
| Sources of Motors/controllers | bill south | Servo Motors and Drives | 1 | 05-05-2005 11:06 PM |
| | |
Linear Mode
