Help with Siemens 840D code.

[bb_24_1]

Can anyone offer any help on the code below? The line with the ***? Does anyone know what the values in parenthesis represent? This is on a Siemens 840D controller.
Thanks

;T1 CENTER DRILL D 0.062
N5T1
wzw
******TOL(.01,1,1)*****
;TOL_SPLINE
cycle800()
traori
N10G54
N15G64
N20S4500M3
N25G01A28.C0F2000.
N30G94X5.411Y-7.4552Z8.F500.
N35G94

[mecheng]

This is probaly a tolerance value to make cycle832 easy to use. You should be able to get an idea of what it does by looking at the program TOL.spf under "user cycles" or manufacturer cycles where you store your programs. PM me if you have more trouble.

[bb_24_1]

Originally Posted by mecheng This is probaly a tolerance value to make cycle832 easy to use. You should be able to get an idea of what it does by looking at the program TOL.spf under "user cycles" or manufacturer cycles where you store your programs. PM me if you have more trouble.

I will check it out. THANK YOU!!