| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-26-2008, 12:06 AM
| |||
| |||
Hey everyone out there, My name is Jay and I'm trying to upgrade the boards on my Denford Micromill so I can run newer software. The old DOS software isn't wanting to control the machine. I'm not really sure what the problem is. Any Help Would Be Welcome!    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| It's RUNNING! | TCGliderguy | Super Tech Controllers, SuperCam & SuperCamXp | 3 | 03-15-2008 09:34 PM |
| HELP CNC Still Not Running | Mr.Chips | Machine Problems, Solutions , Wireless DNC, serial port | 9 | 06-24-2007 09:49 AM |
| Programming Tricks wanted for Running Acromill v1.15.2 software w/o controller Card? | ohallock | General CAM Discussion | 1 | 03-04-2006 02:40 PM |
| New X2 up and running | mjarus | Benchtop Machines | 3 | 01-03-2006 08:41 AM |
| Up and running | bob a job | Hobbycnc (Products) | 0 | 05-13-2005 05:26 PM |
| | |
Linear Mode
