| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
08-16-2008, 01:51 PM
| ||||
| ||||
I am having a hard time locating 4mm & 5mm threaded Brass screws or bolts, I would even take threaded rod. If anyone knows of a source for small quantities, I would appreciate hearing about it. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Last edited by Al_The_Man; 08-17-2008 at 03:16 PM.    |
|
#2
08-17-2008, 03:10 PM
| ||||
| ||||
| Hey Al Spae Naur should have them. If not, I can get Pan heads from McMaster Carr (as long as they don't fall under the "anti-dumping" regulations)
__________________ www.integratedmechanical.ca |
|
#3
08-17-2008, 03:16 PM
| ||||
| ||||
| Thanks, I will try them tomorrow, I did put it in the title but not in the post text, they have to be brass. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#5
08-18-2008, 11:24 AM
| ||||
| ||||
I will keep them in mind for future H/W. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| F&S for 353 brass | ecotectoo | General Metalwork Discussion | 0 | 06-10-2008 02:14 PM |
| Newbie- Weld Brass to Brass | piratesover40 | Welding, Brazing, Soldering, Sealing | 3 | 03-03-2008 07:02 PM |
| PC Based Hardware Controller Kit Needed | pmartin223 | General Electronics Discussion | 6 | 06-13-2004 11:28 AM |
| Brass...why? | creative_mind | General Metalwork Discussion | 2 | 05-25-2004 01:27 AM |
| How can I cut Brass? | cbcnc | General Metalwork Discussion | 3 | 01-13-2004 08:54 PM |
| | |
Linear Mode
