| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-16-2008, 04:12 PM
| |||
| |||
I just joined because I am about to acquire a Kondia FV1 which I would eventually like to convert to CNC. First task is to get it home and it must go through a gate that is about a foot narrower than the table is wide. How do I remove the table so I can get it through? Is there a set of instructions anywhere? I'm a car guy and my present project is an MGB roadster that has been cut down the middle and widened 11" to accomodate an LT1 Chevy engine, 6 speed and Corvette C4 suspension. Jim  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| San Diego, CA Hobby Machinist Group | danswaay | Syil Products | 6 | 12-10-2009 12:36 PM |
| Mentor in San Diego | danswaay | Mentors & Apprentice Locator | 23 | 03-18-2008 03:52 PM |
| looking for a Joe's builder around San Diego | sandiegocadcam | Joes CNC Model 2006 | 0 | 01-02-2008 07:35 PM |
| Anyone in San Diego,Riverside,San Bern?-with IH Mill? | Rich05 | Industrial Hobbies (Support forum) | 1 | 06-13-2007 09:56 PM |
| What are some good surplus places in San Diego? | teilhardo | CNCzone Club House | 1 | 03-12-2004 03:07 PM |
| | |
Linear Mode
