| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-28-2008, 11:28 PM
| |||
| |||
Hello. For part of a prototype, I need an 1/8-inch inner diameter tubular piece. The piece needs to be pliable with some memory. It will be put over the sides of some eyeglasses frames, so I need it to stretch to fit, or I may slit it down the middle to make it easier to put on and take off. I know this piece can be molded, but I am concerned about the expense. Is there a less expensive way to do this for a prototype piece? Which type of tubing/material might be best for this part? Any information you can offer about this predicament will be appreciated. Regards, Amy  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| prototype needed | jimpastorius | Employment Opportunity | 6 | 05-31-2010 12:43 PM |
| Need drawing for prototype | DANTAMPA | Employment Opportunity | 6 | 11-20-2007 06:51 AM |
| pcb prototype | xlukkajr | General Electronics Discussion | 2 | 02-21-2007 03:14 AM |
| [cad] Cnc Prototype Idea... | Brunow | Mechanical Calculations/Engineering Design | 5 | 01-31-2007 07:00 AM |
| Prototype. | impact | Employment Opportunity | 4 | 04-29-2005 02:10 PM |
| | |
Linear Mode
