| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-19-2008, 02:47 PM
| |||
| |||
Hello Someone who knows how to programe tool life and a new "fresh" tool with the same lengthoffset in ISO on a doosan mill with fanuc 18i?  |
|
#2
05-19-2008, 08:51 PM
| |||
| |||
| Do you mean something like "150 parts then M30"? where it just stops and waits for you to change to a tool with same offset? or do you mean "150 parts then M06/T02"? where it goes to next tool in chain that has same offset,etc? Both are relatively simple to write and might be in machine control manual. I'll try to dig out my Fanuc manual and see if I can find it. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tool Life Management | marko440 | Fanuc | 8 | 04-07-2010 03:47 PM |
| Tool Life Management | Jake E. | General CNC (Mill and Lathe) Control Software (NC) | 6 | 11-05-2009 01:13 PM |
| Tool Life Management on Fanuc 16Ii MB | binzer | Fanuc | 1 | 04-01-2008 06:44 PM |
| Tool life | Muzzy | CNC Tooling | 0 | 04-11-2007 04:47 PM |
| Fanuc tool life management | westerfieldcct | General Metalwork Discussion | 7 | 05-23-2006 10:43 PM |
| | |
tool life management 
Linear Mode
