| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-04-2008, 05:28 PM
| |||
| |||
Hi All, This my first time messing with CNC and I am fascinated. I've been lurking around a couple of weeks and I think I'm going to build the JGRO design. The mechanics of these devices are awesome, but my degree (soon to be) is in electrical engineering. The controls and electronic components really excite me. I can't wait to get one built to start messing with the different setups possible. My senior design project involved 2 axis of motion and designing the controls was one of the coolest things I did at school. I hope to extend this into the world of DIY CNC. Anywho, I'm sure I'll post tons of questions later. Till then, GREAT SITE!!!  |
|
| Tags |
| newbie |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1st time | el gordo | GibbsCAM | 3 | 07-19-2007 09:07 PM |
| milling time (not to be confused with hammer time) | barefoot0 | G-Code Programing | 4 | 05-02-2007 06:18 PM |
| Time on Job | greasetattoo | Carken Products (Deskam, DeskCNC etc) | 0 | 03-10-2007 05:30 PM |
| X2 Conversion Time (shopping time) | Micro Rotors | Benchtop Machines | 2 | 03-04-2007 11:11 AM |
| Time | CNCRob | Forum Questions or Problems | 7 | 05-12-2005 02:55 PM |
| | |
Linear Mode
