Heli flyers input needed - CNCzone.com-The Largest Machinist Community on the net!

HomeCNC · #1 08-09-2004, 10:06 AM

What do the experienced R/C helicopter flyers here have to say about the Dragonfly Helicopter that is on Ebay?

Is this a good learning heli? My goal is to go into a nice electric copter one day but don't know where to start to learn this. I can fly R/C planes fine and have been doing this for many years.

CNCadmin · #2 08-09-2004, 11:57 AM

It's a toy, if you serous about learning to fly that is not the one.

CNCadmin · #3 08-09-2004, 11:58 AM

http://www.rcuniverse.com/market/category.cfm?catID=84

Garfield · #4 08-13-2004, 02:14 PM

Take a look on Draganflyer IV instead is on www.rctoys.com
If you want a cool helicopter I bought it 2 years ago and really satisfied

HomeCNC · #5 08-18-2004, 06:00 PM

Well I ordered the Dragonflyer IV. It got a good review from rcuniverse. I'll let you know how my learning process goes.

CNCadmin · #6 04-23-2005, 10:34 PM

So how are things going with your heli?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tranformer input options?	Bloy2004	General Electronics Discussion	6	05-01-2005 10:17 AM
What's needed for complete setup?	LeeWay	Gecko Drives	1	03-09-2005 08:38 AM
Dirction / Step lines!	bigal	TurboCNC	2	02-06-2005 01:51 PM
Active High/Active Low	Sanghera	General Electronics Discussion	21	11-06-2004 08:47 PM
Tool offset input	Mircea	Machine Problems, Solutions , Wireless DNC, serial port	0	05-28-2004 06:16 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)