Pipe/Rod follower with bearings? - CNCzone.com-The Largest Machinist Community on the net!

DennisCNC · #1 10-12-2007, 10:39 PM

I have been looking for a while to find a company that would sell these. So I made a few for now, need it to go on a 1.5" pipe. If some one knows were I could buy them let me know, Please.

Thanks

rustamd · #2 10-12-2007, 11:06 PM

just make your own like in here:

http://www.frets.com/FRETSPages/Mach...bigbender.html

rustamd · #3 10-12-2007, 11:11 PM

and for bearing just get some skate bearing and press them in there(might not work depending on what size shaft you got there)

rustamd · #4 10-12-2007, 11:32 PM

how much load are on them?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Follower rest and long narrow contour	jime	General Metalwork Discussion	0	03-27-2007 06:53 PM
CNC Retrofit A Heath/Torchmate Upright Magnetic Follower Shape Cutter	Weldtutor	CNC Plasma and Waterjet Machines	8	02-04-2007 03:08 PM
Info on Fet power follower for inexpensive small stepper driver?	mpmarino	Stepper Motors and Drives	2	12-15-2006 03:57 PM
emt conduit, galvanized pipe or black pipe?	JohnG	DIY-CNC Router Table Machines	5	05-21-2006 09:24 PM
Cam- gear motor - force applied to follower?	Chris D	Mechanical Calculations/Engineering Design	3	05-05-2006 12:41 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)