Just to say hello

[Cerritos]

Glad I found this site!

I am Ron the manager and developer of the "Virtual Machine Shop" which is a machine tool technology training site. Non profit... this is not spam.

But I would be very appreciative of any pros out there who can contribute to lessons or reviewing/correction/proofing.

Glad to find another place to talk machines... I started sweeping chips off the floor of a machine shop after school in 1956... So I have seen a few things here and there

[ImanCarrot]

Very impressive site Ron!

I specialy liked the animations- they do say that a picture is worth a thousand words.

Thanks for sharing- have stuck it on me favourites

[Geof]

I had a quick look at your website and it is impressive. Probably you have not seen this thread from a few months ago here on CNCzone:

http://cnczone.com/forums/showthread.php?t=35587 "The state of the Machinist trade in the U.S. today, and where will we be tomorrow..."

Some of the opinions expressed in these posts could have been taken from your site .

I think a lot of us know what the problem is, your efforts are a valuable resource for young people who want to get into this occupation but how do we get through to the ones that have been brainwashed into thinking these skills and knowledge are no longer needed?

[Cliff Perry]

Really enjoy site will use it for reference. Just joined my self so to every body out there this Cliff saying Hi.

[walter]

Great website!

[trooper55]

I have to say welcome and Your site is going to be nice to thumb threw its a nice and well built site. Thanks for joining

[Cerritos]

Glad you like my site... I could sure use some volunteers for proof reading and whatnot. Sometimes cant see my own mistakes after reading them 100 times.

WHo is the owner of this site? I'd like to establish a connection.

Ron

[martinw]

Originally Posted by Cerritos Glad you like my site... I could sure use some volunteers for proof reading and whatnot. Sometimes cant see my own mistakes after reading them 100 times. WHo is the owner of this site? I'd like to establish a connection. Ron

Dear Ron,

Brilliant website. Lots there for an ignoramus like me to learn.

I could be wrong, but if you want to contact the owner of CNCZone, try sending a private message to "CNCadmin".

Best wishes,

Martin