![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
| ||||
| ||||
| A couple of nights ago a friend of ours, Josh Magana, a Marine stationed in Fallujah, based in Camp Pendlton, was shot twice by Iraqi insurgents; once in the pelvis and once in the arse. He was flown to Germany in critical condidtion. He can move his fingers and toes, and responds (when he's concious) via eye blinks. He will be flown to Maryland (I believe) today, where he will stay for an undetermined amount of time and then be returned to San Diego, likely at Balboa Hospital. His wife and daughter, (Chantz's girl-friend) will fly to Maryland to be with him until his return. Best wishes and a speedy recovery, Josh. And thank you for what you've done for everybody in the free world. You, and those like you that have sacrificed for us, are true heros, and will not be forgotten. Matt
__________________ Matt San Diego, Ca ___ o o o_ [l_,[_____], l---L - □lllllll□- ( )_) ( )_)--)_) (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Limit and home switches EMC and Mach2? | ESjaavik | LinuxCNC (formerly EMC2) | 4 | 09-29-2008 10:39 AM |
| How do you hook up limit and home switches? | CNCadmin | DeskCNC Controller Board | 6 | 09-23-2007 03:34 PM |
| Home switch position | MrBean | DIY-CNC Router Table Machines | 1 | 12-16-2004 06:00 PM |
| The relationship of limit switches to home switches. | MikeAber | General Electronics Discussion | 4 | 11-04-2004 01:28 PM |
| Limit switches and home switches | viktorcnc | TurboCNC | 2 | 08-03-2004 06:11 AM |