Trying to Identifying a fastener - CNCzone.com-The Largest Machinist Community on the net!

05-06-2007, 06:02 PM

Tagarus

Join Date: Oct 2006

Location: usa

Posts: 1

Trying to Identifying a fastener

permalink

Hi, i'm trying to identify a metal fastener. It's a type of captive pin, with 2 channels on the shaft, it uses a wire clip to keep the pin in the part. One end has a larger head. Any help would be appreciated.

Attached Images

Picture 102.bmp‎ (53.3 KB, 72 views)

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need help identifying	pflynnjr	Stepper Motors and Drives	0	04-18-2007 11:58 AM
Need Help Identifying This Stepper	silver	Stepper Motors and Drives	0	11-12-2006 11:59 PM
Need Help Identifying a Bearing	lerman	Mechanical Calculations/Engineering Design	5	10-08-2006 09:38 AM
Help identifying tools	ecbntmkr	CNCzone Club House	8	07-12-2006 08:59 AM
Help identifying this please	studysession	General Metal Working Machines	38	12-05-2004 01:40 PM

All times are GMT -5. The time now is 02:03 AM.