I need to make an adapter for a power chuck for an A2-5 spindle on a Hardinge CNCIII. My question is the location of the key in referance to the location pin and bolts. Can anyone point me to this information?
Thanks
Charlie Hopkins
You might want to start by looking here.
http://www.bpt.com/index.asp?pageId=6
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com