LinkBack URL
About LinkBacks
No, I wanted to put a Camsoft cnc on my mills, but have been too occupied to get at it. So, I'm still running Shadow controllers.
| | |
What did you set out to do this winter and did you get it done?
Last edited by CNCadmin; 03-15-2004 at 01:10 PM.
No, I wanted to put a Camsoft cnc on my mills, but have been too occupied to get at it. So, I'm still running Shadow controllers.
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
My project is to get a laser and cnc table on-line but my anticipated completion date is fall '04. so I consider myself right on schedule.
stay warm...yes, I barely made it!
Stop talking about it and do it already!!!!!
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I may have, i don't remember what i was supposed to do.Did you complete your winter project?
I'm sure the wife will remind me
PEACE
Posting Permissions
| | |
