I Had Mastercam9 On An Old Computer.just Purchased A New Computer.just Re-installed Mcam9.
I Had Config(system Configuration Under "screen" Command)setup.
(ex:1st Tool On Operations Page Would Be:
Tool #1 #2 #3
Dia. Offset #41 #42 #43 Etc.
Length #1 #2 #3

Somebody Helped Me With This(as The Tool Progresses,so Does The Length And Dia. Offset-starting With #41 And So On).

Now(after New Installation),it Went Back To Defaults.
Dia. Offset Starts With #21 And Length Doesn't Match With The Tool#.
(h--e--l--p)