Newcncer here need help on speeding up mach3

[ozon]

Need Help with mach3 pleases just getting into mach3 I created g code with cambam for 4x8 foot piece of sheet metal for plasma cutting no mater what I set the feed rate 100 to 2000 in cambam the g code runs very slow in mach3 it would take all dam day to cut 5 12x12inch parts out of one thin piece 4x8 sheet metal

Note have no table yet just playing with the software g540 kit on its way

Is it my g code programming with cambam

or mach3 settings

[ger21]

Increase the velocities of the axis in Mach3's motor tuning screens.