Creating a 90 degree arc. FAGOR 8055m

[mehtalmann]

12Apr11 1023 hrs.
Greetings..
Just signed up. I would like to router [or] end mill, a piece of hard plastic: .070" thick, 6" by 7". I will come in at the middle/top G1 for 2", then start a 1" radius, from 12 to 3. Then travel 5" in X, then start the second 1" radius. I want to do this on all four corners. I need the syntax for using X, Y, & R. Thanks.

11Apr11 V.03

000125 ;6” x 7” cover
N05 G0 Z-30.00 ;Safety position
N06 T01 ;Tool: [01]
N10 G90 ;Absolute
N15 G20 ;Units: [Inches]
N20 G70 ;Fixed/multiple cycle
N25 G17 ;Arcs within the [XY] plane
N30 M03 ;Spindle: [On]
N40 S3000 ;Speed: [3000]

N50 G01 X59.265 Y30.150 Z-32.645 ;Travel to part

N60 G01 X59.39 Y30.150 Z-32.770 F200.00 ;Move into part: [.125”]
N70 G01 X59.39 Y32.150 ;Start 1st 1.00 inch radius
N80 G02 X60.39 Y33.150 R1.00 ;Finish 1st 1.00 inch radius

N90 G01 X65.39 ;Position…start 2nd 1.00 inch radius
N100 G02 X66.39 Y32.150 R1.00 ;Finish 2nd 1.00 inch radius

N110 G01 Y28.150 ;Position…start 3rd 1.00 inch radius
N120 G02 X65.39 Y27.150 R1.00 ;Finish 3rd 1.00 inch radius

N130 G01 X60.390 ;Position…start 4th 1.00 inch radius
N140 G02 X59.390 Y28.150 R1.00 ;Finish 4th 1.00 inch radius

N150 G01 Y30.375 ;Last radius [to] beginning of part
N160 G00 X59.265 Y30.150 Z-30.00 ;Reposition/raise “Z”
N170 M05 ;Spindle stop
N180 M30 ;Program end