new plasma table build

[miles peters]

Hi I am a fence builder who is to stupid to know he can’t put a plasma table together so I’v ordered a 4 foot gantry from Dynatorth and I’m about to start to build an 8 foot table I am hoping to be able to pick some brains on this site if I can figure out how to work it.
I am no good with computers so good luck with this project .
The table I want to build is a smaller vergen of a 6x12 in a build thead I have seen on this site.
I thought I would put a center slat holder on a crank so I can just drop the slats in then crank them to an arc does that make any sense.
I went to a industrial refrigeration outfit and found a used fan for 200$ thay said it was 4000 cfm but it's only 1h.p. its built like a large furness fan were the air gos in from both sides and the motor and bearings are in the steem however the motor is sealed so I'm hopping it will stand up for a littel while.