| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNCzone Club House Discuss everything in between CNC. THIS IS NOT A TRASH BIN. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-16-2010, 10:13 AM
| |||
| |||
I am using DeskCNC and everything works fine until I stop or pause a program. At this point my controller goes into "EMStop" and I can't get it back functioning. I shut everything down, reboot my computer, disconnect my serial cable, reset everything, start up again and no matter what I do I can't get the table to allow me to jog or run a program. Sometimes if I just shut everything down and wait a few hours it run's normal again until I get that dam "Emstop" again and I am dead in the water. Any ideas?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need A Quote- desk nc | diveneyq | CNCzone Club House | 0 | 02-10-2009 08:19 AM |
| Desk CNC Help | xichanceix | BobCad-Cam | 3 | 04-18-2007 04:36 PM |
| desk cannon | MR2Navy | Hobby Discussion | 17 | 05-24-2006 10:44 AM |
| Desk PCB | CNCadmin | Carken Products (Deskam, DeskCNC etc) | 4 | 05-05-2004 01:46 AM |
| Desk Engraver problem | Fran | Carken Products (Deskam, DeskCNC etc) | 7 | 05-10-2003 01:55 PM |
| | |
Linear Mode
