| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNC Wood Router Project Log Post your CNC machine building log here only. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-28-2008, 02:41 PM
| ||||
| ||||
Any body who want to install cheap MDF based 4th axis on machine, must see the following thread  Diy- Build Router In 10 Days Regards Khalid Last edited by Khalid; 09-29-2008 at 09:13 AM.    |
|
#2
09-28-2008, 05:42 PM
| |||
| |||
| That's really a nice addition to your machine Khalid! It couldn't be much simpler than that. Good job. I have to say it though, somebody I know personally would have to make one from red oak and purple heart to make it look right on his own machine.  So now I suppose you are going to design a simple means to rotate the router front to back and side to side. (axes B and C?) CarveOne
__________________ "A $1,000 electronic device will almost always protect a ten cent fuse." |
|
#3
09-29-2008, 09:10 AM
| ||||
| ||||
| CarveOne, May be I will make a jig to hold the router 90 degree, but currently I am not planning to motorized myB-axis 5-Axis CNC is on my drawing board, Hope I will finish it within two weeks, and building will offcourse take a couple of months |
|
#6
12-22-2008, 06:22 PM
| |||
| |||
| Hi Khalid, It seems that you have other projects and interests as well as this one, so if this project takes a while I'll still be checking for any updates you post. CarveOne
__________________ "A $1,000 electronic device will almost always protect a ten cent fuse." |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| REALLY cheap CNC! | blades | Benchtop Machines | 4 | 04-11-2008 08:32 PM |
| 2-axis ghetto cheap | blades | Benchtop Machines | 19 | 01-16-2008 04:29 AM |
| 5th Axis on the Cheap? | M30 | Haas Mills | 15 | 07-24-2007 09:45 AM |
| Dirt cheap Polyester PETP rods for Z axis??? | andy_ck87028 | Linear and Rotary Motion | 6 | 06-20-2006 04:45 AM |
| | |
CHEAP DIY 4th AXIS SETUP (MDF BASED) - MUST SEE 
Linear Mode
