| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNC Wood Router Project Log Post your CNC machine building log here only. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#37
 
12-15-2008, 09:05 AM
| |||
| |||
It's been more than a month since my last post.....and finally I've got a little further. After a lot of contact with probotix and trying every possible solution I ended up replacing the breakout board, the power supply, two drivers and heatsink. To bad it took forever for all the parts to clear customs, but I've got my motors moving!!! see attached movie. Thanks Chris from Probotix for replacing all the parts at no costs. They must have spend a fortune on shipping..... Finally, on to next fase! more news soon.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to mill inside an area and not over an area? | jedioliver | Visual Mill | 10 | 02-21-2007 11:52 PM |
| Looking for Mentor in Bay Area, CA area | Allistah | Mentors & Apprentice Locator | 3 | 11-08-2005 02:05 PM |
| the cut area? | planescott | DIY-CNC Router Table Machines | 1 | 09-20-2005 06:01 PM |
| a DXF in the FTP area | inthedark | Employment Opportunity | 11 | 03-10-2004 09:01 PM |
| | |
Linear Mode
