| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNC Wood Router Project Log Post your CNC machine building log here only. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-05-2007, 09:04 PM
| |||
| |||
i was hoping to find out what venders/ manufacture has the best spec for torque for the buck... want build a 5'x 9' table was to told PK296A1A-SGis 7.2, 2-Phase Stepping Motor http://catalog.orientalmotor.com/ite...=prod&filter=0 would do the job. But want to get the bang for my buck any other good ones out there?, or where to buy them cheap?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with motor stalling due to motor/lead screw alignment | Bimmerkc1 | DIY-CNC Router Table Machines | 3 | 01-24-2010 06:12 PM |
| New 6 Jaw Buck Chuck Backplate | Woodenspoke | General Metalwork Discussion | 6 | 01-21-2007 02:22 PM |
| Buck | bucking | General CNC (Mill and Lathe) Control Software (NC) | 0 | 11-09-2006 12:50 PM |
| Best CNC Benchtop Mill Bang for the Buck | fuzzman | Benchtop Machines | 9 | 07-24-2006 08:52 PM |
| Buck Stove - Add 3 way manual fan switch? | wjbzone | General Electronics Discussion | 1 | 11-07-2005 02:50 PM |
| | |
Linear Mode
