LinkBack URL
About LinkBacks
Here is the base.
| | |
This thread is to document my attempt to build a CNC. I am currently in to the second version of it. have fun and any recommendations and/or comments are welcome. Thank you.
Here is the base.
Last edited by Flemp; 05-13-2010 at 10:14 PM.
Here are the additions of the X rails and the X carriages.
Last edited by Flemp; 05-13-2010 at 10:14 PM.
There was a laps in time with my photos.
These pictures jumps to the addition of the X, Y and Z rails and carriages.
Last edited by Flemp; 05-13-2010 at 10:13 PM.
Here is the X push bar to the X rail carriages.
Last edited by Flemp; 05-13-2010 at 10:13 PM.
Here is a close up of the Y rail, Y carriage and Z rail support.
Last edited by Flemp; 05-13-2010 at 10:12 PM.
This is a close up of the Z rail and Z carriage.
Last edited by Flemp; 05-13-2010 at 10:11 PM.
And again another jump in time in the photos. The is when i started installing the screws and stepper motors.
Last edited by Flemp; 05-13-2010 at 10:10 PM.
Here is the table completed.
Last edited by Flemp; 05-13-2010 at 10:10 PM.
Here is a picture of the shaft coupler that i used in the first build.
Last edited by Flemp; 05-13-2010 at 10:09 PM.
these are pictures of the stepper motor controller box.
Last edited by Flemp; 05-13-2010 at 10:08 PM.
finally here is the workstation for the CNC.
Posting Permissions
| | |
