| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNC Wire Foam Cutter Machines Discuss DIY CNC Foam Cutting here! (R/C wing cutting etc..) |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
09-06-2006, 09:59 AM
| ||||
| ||||
|
__________________ Consistency is a good thing....unless you're consistently an idiot.    |
|
#3
09-06-2006, 09:59 AM
| ||||
| ||||
| Do a search through the forums here, lots already mentioned. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
09-06-2006, 10:06 AM
| ||||
| ||||
| What is the standard size people strive for for a simple design, and gear reduction? |
|
#5
09-06-2006, 10:41 AM
| ||||
| ||||
| Try McMaster Carr. Expensive but speedy delivery and they ususally have what you are looking for! Bill
__________________ billyjack Helicopter def. = Bunch of spare parts flying in close formation! USAF 1974 ;>) |
| Sponsored Links |
| |
|
#6
09-07-2006, 10:14 AM
| |||
| |||
| Point of correction: Cogged timing belts and/or chains are used with SPROCKETS, not gears. Gears transmit power directly from one to the other via tooth to tooth contact. Ask for and/or purchase the wrong thing, and you could become highly disappointed with the parts you get. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
