| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNC Wire Foam Cutter Machines Discuss DIY CNC Foam Cutting here! (R/C wing cutting etc..) |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
01-19-2012, 09:17 PM
| ||||
| ||||
I have a 4 Axis TB6560 CNC Stepper Motor Driver Board Controller.And the motor hook up. A+ A- B+ B- I tryied A+ as A red A- as a black B+ as B white B- as b green The motor are on but all that happens the relay clicks
__________________ 2 wrongs don't make a right But 2 Wrights makes a Airplane Kevin Matney www.Matneymodels.com 734 - 848 - 8195 "IN GOD WE 'TRUST " (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
#3
01-24-2012, 09:45 AM
| |||
| |||
| If you have an 8 wire motor (23-205-DS8) you are partially correct. The motor has 4 coils and you are connected to each end. Connect the yellow and blue together and also connect orange and brown together. If it does not run then reverse the red and black connections. Try it. John |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4 Axis TB6560 CNC Stepper Motor Driver Board + Cable | gabrivene | EBAY ADS | 2 | 01-15-2012 04:33 PM |
| CNC stepper motor driver board TB6560 | Chaparro1973 | Spanish CNCzone | 4 | 12-27-2011 12:00 PM |
| Need Help!- TB6560 4 Axis CNC Motor Stepper Driver 3A 12-36V | vicsrc | Want To Buy...Need help! | 0 | 03-10-2011 10:57 AM |
| need help with 3 AXIS (TB6560) CNC DRIVER BOARD | Jason Miller | General Electronics Discussion | 34 | 01-06-2011 12:25 PM |
| 3 Axis TB6560 Driver Controller motor sizing | crazydiamond | Stepper Motors and Drives | 4 | 01-05-2011 07:21 AM |
| | |
Linear Mode
