Source for tool bits for pcb isolation routing - CNCzone.com-The Largest Machinist Community on the net!

guru_florida · #1 01-24-2008, 08:43 PM

I am in NA. I am looking for good mill bits for pcb routing. There was another thread on here that mentioned a source in the uk. The end looked like the stylus of a pen. It looked like it would produce nice fine pitch isolation cuts.

I used a 60 deg diamond cutting bit, it worked but it makes pretty wide cuts, probably 20 mil I guess.

Thanks,
Colin

kn6za · #2 01-24-2008, 09:01 PM

Colin,

I have been selling pcb router bits, check out my site at www.drewtronics.net

Andrew

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need to source bits	eloid	CNC Wood Router Project Log	10	03-17-2007 12:22 PM
Good source for wood bits	Art Ransom	WoodWorking	2	10-12-2006 11:00 PM
PCB Trace Isolation - Minimum Track and Isolation	ahoodlum	General Electronics Discussion	11	09-25-2006 11:02 PM
PCB Isolation Routing experiences	10bulls	General Electronics Discussion	26	12-06-2005 04:56 AM
What type bits for routing PCBs?	cp8071	DIY-CNC Router Table Machines	4	02-22-2005 10:08 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)