FEDEK BAR FEEDER

[CHANDRU]

Dear Friends,

We have few POLYGIM M/c's with FEDEK Bar Feeder.

The BarFeeders are equiped with S7-200 PLC(SIEMENS).When we want to take the backup of the plc programme surprisingly the S7-200 IS PROVIDED WITH PASSWORD by the machine manufacturer and we are not able to upload the programme from yhe PLC.The manufacturer is reluctant to reveal the password.

Will anybody help me?

Thanks and Regards,
CHANDRU

[So CA Machinist]

Chandru:

Nobody has contacted me about our Diamond 20CSB. Have him call me. (909) 390-9595 ext. 123 or email me at RHartman@horizonhobby.com


Thanks,

Ron - Southern CA

[lyfordln]

Try all zeros. start with (4) zeros and and add a "0" until you get in

[squiz81]

Hi Chandru - I know this is a bit off topic but can you offer some help on programming the bar feeder to pick up a new bar? I can get it to feed the bar in when required, but I can't seem to get it to pick up a new bar. (The barfeeder is a Fedek DH-65 and the machine has a Fanuc oi-TC controller)
Much appreciate.

[cogsman1]

Been awhile since I ran one but the guy that installed the one I used was
Joel Jones of MTA International West Chester, OH.
ph# 262-473-1650 cell# 513-543-0973
Very nice guy and very good with the feeders too.