centering problem - CNCzone.com-The Largest Machinist Community on the net!

settingbur · #1 03-06-2008, 10:02 PM

When centering machine (F20) an dthen using g0w-2.5 cod to put machine at -63.50 and begin to run production cycle after the first cycle instead of returning to -63.5 it returns at -64.008. Why is it doing this, and how can I prevent this. Thanks

cogsman1 · #2 03-07-2008, 06:37 AM

Do you have any "G50" commands in the program that you are NOT canceling correctly? That is usually the problem when that is happening.

settingbur · #3 03-07-2008, 07:47 AM

Originally Posted by cogsman1

Do you have any "G50" commands in the program that you are NOT canceling correctly? That is usually the problem when that is happening.

I will take a look at that tomorrow, was editing program yesterday so I may have inadvertently deleted one of those G50's thank you.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Centering Chuck	shadowdog500	Mini Lathe	13	12-02-2007 06:25 PM
Self centering fixture	Hack	Mechanical Calculations/Engineering Design	18	07-13-2005 12:09 AM
Help Centering a Conical part.	rustyolddo	General Metalwork Discussion	1	07-11-2005 08:03 AM
Centering a 4-Jaw chuck	gdl357	Mini Lathe	10	09-20-2004 06:24 PM
Centering blocks	Hobbiest	DIY-CNC Router Table Machines	4	02-09-2004 11:57 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)