Need Help! TSUGAMI BS 18 III - CNCzone.com-The Largest Machinist Community on the net!

rahman161206 · #1 10-08-2011, 01:18 AM

Dear ALL

A few month ago I buy second hand machine,
Tsugami BS 18 III controler by Fanuc MSC 501.
But I am not get manual book for programing.
I can't make program because no programing manual.
Can you help me for made program standard and explanation.
I need M code and special G code explanation for make the program.
Can You help me to solve my problem.

Best Regards

Rahman

txcncman · #2 10-08-2011, 09:04 AM

The basics for programming Fanuc control lathes are the same. Write you program using the basics and see what errors you encounter and then ask back here. If you do not know the basics for programming Fanuc control lathes then you need to buy some books and go to school for it.

DCogswell · #3 10-08-2011, 01:24 PM

I'll help you out, send me an email:
dcogs1@msn.com

David

rahman161206 · #4 10-09-2011, 10:15 AM

I know the basic program Fanuc,
I would like is a special g code and M code that is in the machine tsugami BS 18 III. Since I try to create a program similar to the machine type B0 tsugami could not running.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Thoughts on Tsugami	timan	CNC Swiss Screw Machines	25	10-23-2011 11:29 AM
Need Help!- Fanuc 6TA & Tsugami T-NCM 70/160	vanwyksc	Fanuc	1	04-24-2011 05:55 AM
Need Help!- tsugami S25(D)	lukajt	CNC Swiss Screw Machines	0	09-21-2009 09:05 AM
Tsugami PL3B Help	Kevin Taylor	CNC Swiss Screw Machines	1	09-05-2009 09:10 PM
Newbie- Tsugami T-SPD	rmcclane	Want To Buy...Need help!	1	10-25-2008 02:20 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)