Need Help!- tiny RF Connector

[subm]

Folks:

I am looking for some help. See attached photo. The material is BeCu. There are at least two parts pictured. My problem is with the larger part or "body". This part is approx. 0.150 inches long. It involves saw slotting and forming of the created "fingers". The application is RF Connectors There are a whole lot of +/- .001 tolerances. I need a shop that makes these kind of parts on a regular basis. Tolerance control and burr removal are critical. Unfortunately, if you haven't been through this learning curve, you probably can't help me. If you have, you could look forward to some good, steady business.

If this question is inappropriate for this forum, I apologize in advance.

Thank you.

[DCogswell]

Originally Posted by subm Folks: I am looking for some help. See attached photo. The material is BeCu. There are at least two parts pictured. My problem is with the larger part or "body". This part is approx. 0.150 inches long. It involves saw slotting and forming of the created "fingers". The application is RF Connectors There are a whole lot of +/- .001 tolerances. I need a shop that makes these kind of parts on a regular basis. Tolerance control and burr removal are critical. Unfortunately, if you haven't been through this learning curve, you probably can't help me. If you have, you could look forward to some good, steady business. If this question is inappropriate for this forum, I apologize in advance. Thank you.

I've got a lot of experience in the connector industry. Feel free to contact me: dcogs1@msn.com

thank you,
David Cogswell

[chet470]

I sent you a email

[chet470]

please contact me at bwclutter@comcast.com

[DCogswell]

I sent you a private message with my number. I also tried your email but it came back as undeliverable.

[chet470]

im sorry my email is bwclutter@comcast.net. the email was meant for subm