Sync display question - CNCzone.com-The Largest Machinist Community on the net!

Brian-Gilliam · #1 05-12-2011, 10:49 AM

Someone recently told me that you can write a macro in MS word to view swiss code in sync display. Anyone have experience or advise?

BG.

DCogswell · #2 05-13-2011, 02:37 PM

Are you talking about "Word" opening both files and horizontally aligning the M200/M500 sync codes?

If so, I haven't seen it before but, if it's possible, that would make programming a little easier.

I believe Predator has that capability and I have seen it before but, I don't remember which software that was.

ProProcess · #3 05-13-2011, 03:34 PM

Originally Posted by DCogswell

...I have seen it before but, I don't remember which software that was.

WinCNC from MCC does this and more

ProProcess · #4 05-13-2011, 03:41 PM

Originally Posted by Brian-Gilliam

Someone recently told me that you can write a macro in MS word to view swiss code in sync display. Anyone have experience or advise?

BG.

If you know Visual Basic, you can do most anything within any of the Office products as they all have VBA available to you.
We've used it to make some GUI driven progamming aids.
It's fun too.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
X axis out of sync	Arif Fayyaz	Controller & Computer Solutions	2	03-28-2011 06:26 AM
Plasma Cam 98-z cut sync problems???	ziptie007	PlasmaCam	5	02-11-2009 08:07 PM
Sync Spindles Help	chucker	Fanuc	0	11-26-2008 11:12 AM
Spindle Sync. Question?	crash80	Fanuc	4	10-02-2008 02:18 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)