New Machine Build How do you get a table FLAT, TRUE & SQUARE? - Page 3 - CNCzone.com-The Largest Machinist Community on the net!

WSS · #25 07-28-2009, 10:03 PM

Originally Posted by Edwardo

Well guys as fate would have it i was called back to work early, i have to leave again on Wed.... should be back around mid Aug sometime.... good luck on your builds and retro fits.... this is the first time since owning my table i havent even had a chance to light it up on a break and its a real downer...

EDD

Edwardo,
Does this mean you will have twice the time to cut when you get back or will you have to split it with hanging drywall?

Edwardo · #26 07-28-2009, 11:24 PM

It turned onto one of thoughs tv shows were it comes down to the wire to get it all done in time, well its as done as its going to be for now.... just the ceramic tile to do when i get back... the good thing is i didnt have time to unpack so im ready to go... Aculpoco tommorow night....

EDD

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie- Flat Table ?	Ed from NY	Syil Products	23	08-30-2009 08:13 AM
100% flat table for flat bed lamination	Bernhardsen	Printing, Scanners, Vinyl cutting and Plotters	4	08-24-2008 08:31 AM
Sieg X1, X2, X1L true table travels?	boom	Benchtop Machines	2	11-01-2006 05:34 PM
With a reference flat, how does a machine bed longer than the ref get scraped true ?	bobJandal	Mechanical Calculations/Engineering Design	13	09-18-2006 01:03 PM
How to make Parallel Square Beam/pipe without flat surface ?	Calico	Welding, Brazing, Soldering, Sealing	8	06-26-2005 08:13 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)