Waterjetting Rubber

[Miguel Gonzalez]

What is a good way to secure rubber sheeting onto the cutting cable so it doesn't move? I would like to try using waterjet brick but the sizes available are too small (we're cutting a 3' wide by 10' long sheet).

We tried using a thin gage aluminum sheet underneath before, but this slows down the cutting speed. What have you guys tried?

[JerryFlyGuy]

Have you tried sandwiching it between a couple sheets of plywood or something?

[DareBee]

Yup
Sacrificial sheets of some sort is required.
You will have to grin and bear it on the cut speed.
Unless you want to make dies and cut your shapes.

[cagedxj]

I have used a thin sheet of crs on top and underneath with heavy weights holding it down. worked pretty well.