| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| CNC Plasma and Waterjet Machines Discuss building, operating CNC Plasma, waterjet and EDM machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
 
08-18-2008, 09:40 PM
| |||
| |||
| I got my machine up an running great without THC. Everything works fine and I can cut parts. But when I hook up the Arc voltage lines I get Communication Errors Is this because of the HF? In the picture there are 2 wires which I have hooked up red and black they were backwards when I took this photo but they are now opposite (positive ground. I get a voltage reading with the meter hooked up and cutting 1/4" mat it reads 109 volts What the Thermodynamics book calls for) and varies depending on torch height. My question is could I have it hooked up wrong? http://www.cnczone.com/forums/attach...1&d=1219112002 http://www.cnczone.com/forums/attach...1&d=1219113517  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| High voltage & high power servo drive design | Xerxes | Granite Devices | 32 | 08-22-2008 09:24 PM |
| Thermal Dynamics 4Xi | Grunge-Fut | Plasma, EDM and other similar machine Project Log | 1 | 06-06-2008 08:34 AM |
| Problem- thermo part sticking to artwork? | spock | Vacuum forming, Thermoforming Etc | 1 | 05-05-2008 09:24 PM |
| High Frequency shaft | rctoni | General Electronics Discussion | 1 | 10-20-2007 12:05 AM |
| Stepper-High Pitch/Frequency Noise | azt34 | Stepper Motors and Drives | 0 | 05-18-2006 07:41 PM |
| | |
Linear Mode
