Water Table Question ! - CNCzone.com-The Largest Machinist Community on the net!

Pure-Powder · #1 04-23-2008, 10:14 AM

I was wondering if there is anything I could add to the water in my water table to help keep the water from turning like crap so fast!

totalfab06 · #2 04-23-2008, 11:47 AM

Plasma Quench is what I use. I have not had any problems so far. http://www.koalindustries.com/plasmaquench.html

Pure-Powder · #3 04-23-2008, 12:19 PM

Thanks totalfab06 , I new someone here would be able to help..

Normsthename · #4 04-23-2008, 02:15 PM

I put Soda Crystals in my Water Table.
It stops the water from 'going off'
I cleaned the water out of my Water Table for the first time in 2 months.
It was really nasty, very dark in colour and I removed about 5 lb of sediment from the bottom of the tank

At least the water table stopped all that nasty plasma dust from getting into the air

My Water Table only holds approx. 16 gallons, and I need to make a new tank with greater capacity, and it will also have a separate air/water tank

I did notice that after cleaning my tank, and replacing the water the smoke was noticeably less when cutting.

Andy

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Water table question	DRL	CNC Plasma and Waterjet Machines	2	03-28-2008 12:23 AM
Water Table Question !	Pure-Powder	CNC Plasma and Waterjet Machines	4	03-06-2008 09:09 PM
Water Table or Down Draft	hgarwood	CNC Plasma and Waterjet Machines	3	12-25-2007 12:28 PM
Water Table Question	DISCONNECTED	CNC Plasma and Waterjet Machines	5	11-03-2007 01:58 PM
Water transfer techniques for water table?	Knut	CNC Plasma and Waterjet Machines	3	02-02-2007 10:52 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)