ghost is here - CNCzone.com-The Largest Machinist Community on the net!

nerginer · #1 02-18-2007, 03:52 AM

Hi,

I want to ask you something about interfarance. I build up my plasma table. Every thing works fine excpet When the plasma starts with a M3 command the 10'' lcd monitor goes black and then starts again. The monitor is on the machine so I can not take it away. Can someone help me to solve this issue

Regards,
Nuri Erginer

millman52 · #2 02-18-2007, 11:19 AM

It may be a ground problem. The plasma needs to be grounded seperately from your computer/monitor & machine ground.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)