Help Which Post Processor? - CNCzone.com-The Largest Machinist Community on the net!

DISCONNECTED · #1 01-21-2007, 08:08 AM

HAVE A DYNA CNC TABLE.RUNNING MACH 3 AND SHEETCAM.THC IS CandCNC.WHICH POST PROCESSOR DO I USE IN SHEETCAM? SORRY,NEW
TO CNC PLASMA.CAN SEE IT IS GOING TO HAVE A LONG LEARNING CURVE....

grinder_gary · #2 01-21-2007, 01:20 PM

I am sure you need to get the THC 1000 post processor. It will be posted on Sheetcam site or the Yahoo group site for sheetcam. I do believe that the post processor is in the sheetcam main folder, under posts there is a post called Plasma THC1.
Gary

DISCONNECTED · #3 01-21-2007, 01:55 PM

Thanks Gary And Thanks To Everyone On This Site For Sharing Their Knowledge....................

Torchhead · #4 01-22-2007, 07:36 AM

The correct post processor should be available from DynaCNC. If you have the floating head (touch-off system) then you can also download a post processor from my support site (CandCNCSupport Yahoo Group). You are welcome to join. We can also answer some of your general plasma cutting questions since we have a full time steel cutting business as well.

Tom Caudle
www.CandCNC.com
www.FourHillsDesigns.com [commercial decorative steel cuttings]

DISCONNECTED · #5 01-22-2007, 08:49 PM

Thanks Tom

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Post Processor	scubanick	Surfcam	16	01-31-2010 09:05 AM
post-processor	JDW	General CNC (Mill and Lathe) Control Software (NC)	4	04-02-2008 03:23 PM
Post processor	andyt	Deckel, Maho, Aciera, Abene Mills	3	06-02-2006 07:05 PM
post processor	jimini	Carken Products (Deskam, DeskCNC etc)	1	10-02-2003 10:55 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)