Anyone have a OMAX waterjet table?

[Verfur]

the solids recovery/removal system is working but very slowly it need a filter system as the water runs through so fast that gravity does not get the complete job done. I have thought that one day I would try a shredded PVC type filter like fish pounds just have not got a round to it yet.

Use a thicker peice of metal to set the tool hieght that has a known thickness.

Please keep me posted if you come up with a pendent setup.

John

[jderou]

Anyone had much success etching thin (~.063) aluminum? I've tried low pressure, and adjusting some of the timers, but I can't keep it from blowing through at the corners and endpoints.
Haven't tried water only yet though. I don't want a deep etch, just enough to be legible.

[gman]

Originally Posted by Verfur the solids recovery/removal system is working but very slowly it need a filter system as the water runs through so fast that gravity does not get the complete job done. I have thought that one day I would try a shredded PVC type filter like fish pounds just have not got a round to it yet. Use a thicker peice of metal to set the tool hieght that has a known thickness. Please keep me posted if you come up with a pendent setup. John

We have the SRS system and we made the mistake of keeping it off for 2-3 weeks--what a mistake!!! It took 3 men all day to manually clean out the tank to free up the screens on SRS. This will never happen again

[jderou]

Gary,
is your wireless keyboard waterproof?
Just wondering if anyone makes one. I haven't found a wireless waterproof keyboard yet.

[gman]

Originally Posted by jderou Gary, is your wireless keyboard waterproof? Just wondering if anyone makes one. I haven't found a wireless waterproof keyboard yet.

http://www.ruggedtech.com/

[jet2009]

Hi Greg,
Do you still run a Omax Waterjet?
Im currently a Mitsubishi Waterjet owner/operator, but very unhappy with my machine!
What can you tell me about the Omax with tilting head?
Im looking at the 10x13' machine

Thanks!

[gman]

Very happy with Omax and the tilt a jet, makes a big difference on thicker materials. Also have the terrain follower option. Customer service for the machine is excellent, they have technicians on the phone who know what they are talking about and know how to explain procedures. Hope this helps

Gary

[laka]

We have a 55100 with Tilt and it does make a big difference on thicker material. You can even notice taper on 1/8" material if you turn tilting off. We've cut 4" thick aluminum with less than 0.005 difference in size top to bottom. Excellent customer service.