pierce delay in Mach 2 ? - CNCzone.com-The Largest Machinist Community on the net!

Redline · #1 08-31-2006, 10:01 AM

How can I change the pierce delay in Mach 2. It seems to be sitting there too long.

Torchhead · #2 09-02-2006, 11:50 AM

Open MACH2. Go to Ports & Pins/Spindle Output (may be in another spot in MACH2, haven't run it in over a year). Turn off any Spin-up spin down delay.
Let the Arc Good signal set the pierce delay.

garydunlop · #3 11-13-2011, 07:58 AM

hi redline i had same problem, [was sore on tips], had turned off any spin up/down delays still no good so with some long evenings i found in general configuration look for g04 dwell in ms and click it off or switch it off it worked fine after that..

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)