mitsubishi wire cut DWC90 C2

[camay]

my edm now cannot run.the machine system software maybe corrupted.i have the back up disc but the its spoil.can anybody advise me...need help...

[nastek]

Originally Posted by camay my edm now cannot run.the machine system software maybe corrupted.i have the back up disc but the its spoil.can anybody advise me...need help...

hi,
you need the new system disk, the disk can't back up.
BRD****, please contact the agent.
i have one system disk, please tell me disk version BRD****

nastek

[hadi]

hi
iam new comer in Wire cut machine ,
by the way , i have some problem in my wire cut Machine
my machine is Mitsubishi FA10 PS and controller model W30FP2

while i transfer NC data from Flopy disk and RS232 cable there `s error " Input Data Error "

any body can hel me...

there`s any

[nastek]

Dear Hadi,

Your setting isn't complete yet, probably comes from RS232 cable and parameter from the PC.
Mitsubishi use 7-2-4800, parity : even
if any question please send PM..

[gm3211]

If this is like most Mitsubishi controls; there are several devices and input/output options. Ideally make them all the same and you should resolve the issue.