Plasma Cutter

[mikie]

Hey gus,

I was looking at fitting a plama torch to my CNC and as i know nothing about plasma was hoping you could fill in some answers.

1. I wish to cut 9mm (5/8-7/16")plate, what size plasma unit should i be looking for?
2. What should i be looking out for when adding this unit to my table?

cheers
Michael

[bill565]

Michael,

Hypertherm 1250 should handle the plate.
One item to consider for adding this to your table is 1) keep the hi voltage from the low voltage for drive wires, sensors, and 2) you will need a air compressor. 60 gal minimum.
Both the cutter, and air compressor will probably require higher voltage than simple outlet power, so additional concerns about voltages available to the table are also to be considered.
The final concern, will be the smoke, and slag from the table. Additionaly, metal slats should be used to place the metal on, instead of the support for a router.

HTH Bill

[mikie]

Thanks Bill,

There is quite abit to look over before i can proceed down this path.

Thanks
Michael

[Dave257]

when you say "my cnc" what do you mean. is it a table designed for plasma. don't try to use a cnc mill or other rmachine to add a torch to. the dust and smoke will ruin it in a matter of days.


Dave

[Craig Matthews]

Can anyone out there help me. I have a Hypertherm 2000, old model. The software on it has been destroyed. I am looking to install new but don't know where to go for help. Anyone please advise.

[jimcolt]

There is a Hyperthem HT2000 plasma cutter.....it is still in production at Hypertherm....but it does not have software.

Are you talking about the CNC controller on a cutting machine with a Hypertherm HT2000 plasma? If so, what is the brand and model of the CNC control...and is that what you need the software for?

Jim Colt Hypertherm

Originally Posted by Craig Matthews Can anyone out there help me. I have a Hypertherm 2000, old model. The software on it has been destroyed. I am looking to install new but don't know where to go for help. Anyone please advise.

[Craig Matthews]

The CNC electronics comes from CR Electronic Advanced Plasma. I believe they are out of business now. Model #HD 6-25.
For some reason it has crashed and it no longer communicates with our PC through the software if that make sense.

[jimcolt]

CR Electronics, an Italian company...went out of business about 10 years ago. There is a company in the US that used to sell CR machines in N. America....they may be able to help you with machine support. They are called Cutting Systems Incorporated. Cutting Machines | Flame Cutting Machines | Plasma Cutting Machines - Cutting Machines

Jim

Originally Posted by Craig Matthews The CNC electronics comes from CR Electronic Advanced Plasma. I believe they are out of business now. Model #HD 6-25. For some reason it has crashed and it no longer communicates with our PC through the software if that make sense.