Air filter/dryer - LaMan vs. Eliminizer? - CNCzone.com-The Largest Machinist Community on the net!

I Lean · #1 03-20-2011, 04:09 PM

I just got a used Powermax 45, and it came with a Hypertherm Eliminizer filter attached to it. On the recommendation of my guy at Airgas, I have been planning on buying a LaMan filter since they seem to work well. Does anyone have any experience with the Eliminizer that can tell me how well it works? I can't find any info on it on Hypertherm's website or anywhere else.

The LaMan is quite a bit less expensive, and I'm not opposed to buying it if it will work better than the Eliminizer, even though I now own that one.

jimcolt · #2 03-23-2011, 09:28 AM

The Hypertherm filter works fine, actually has almost identical capabilities as the Laman filter. It is important with either one that you regularly drain moisture from your compressor...especially in humid weather.

Jim Colt

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Refrigerated air dryer question	tinman13	CNC Plasma and Waterjet Machines	10	12-11-2010 07:54 AM
air dryer	grogsroom	CNC Plasma and Waterjet Machines	2	12-12-2009 07:57 AM
Need Help!- NEWBIE Power Line filter (Transformer vs. Filter)	cjchands	General Electronics Discussion	5	09-25-2009 08:36 PM
Newbie- Need an Air Dryer Solution	Dartok	CNC Plasma and Waterjet Machines	14	08-25-2008 06:12 AM
Figuring out VMC air CFM needs for an air dryer?	SRT Mike	General Metal Working Machines	6	06-21-2006 11:17 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)